A year ago I purchased a 9700 basic setup (i.e. 9700 MIDI-CV, 9720 VCP, 9730VCF, and 9710 VCA.) I have just started to expand the setup with other modules.
One thing that I always wanted and is part of my intended upgrade is a ring modulator. I have decided to use the CA-9 as a base.
I will keep everyone informed as to how it goes, but before I get much further into it, does anyone have any suggestions to make it easier to integrate into the 9700 series. The obvious things such as knobs, and 1/8 inch jacks, as well as replacing the slide switch with the 9700 style toggle switches are so obvious that I made those purchases even before starting the kit. But there are still the other less obvious ones. For instance I get the feeling that the CA-9 is intended to work primarily with guitar level signals which appear to average about -10dB to -20 dB while the 9700 seems to run a bit hot at about +5dB to +10dB. Furthermore are there any issues involved in tying the CA-9 into the unregulated +/- 18 volt 9770-u.
In general, is there anything that I should be aware of that I am not even thinking about?
A similar function is available by connecting multiple VCO waves through the Triple VCA/Modulator. Connect one wave to the VCA A input and the other wave to the VCA A Modulation input. This provides a balanced modulator effect which a ring modulator provides, and the CA-9 project mimics. It's extra harmonics added to the input signal for a 'de-tuned' short wave radio sort of sound good for complex tones or robot-like voices.
To use a CA-9 project in a FR-7 chassis powered by the 9770U, you'll need to drill holes to mount the printed-circuit-board to a FRB panel and for the controls, switch (sub'ing a toggle switch for the slide switch), and connectors. Then, for adapting it to the +and- 18v supplies, add a couple of 9.1v zener diodes in parallel with the Cs 7 and 9 power supply input filter capacitors (the banded cathode ends to match the plus poles of these electrolytic capacitors).
Use the 330k resistor for R12 as suggested for line-level use, and either attenuate the waves input to the CA-9 by running through VCA L and/or VCA R and using the L+R output (half of the maximum input to L or R, but also variable by the Pan setting), or, substitute a lower valued resistor for R17 (a 47k makes IC1A work with 0.5x gain).
Locate an individual PAiA product to review questions submitted by users and answers supplied by the PAiA support staff.
1 post • Page 1 of 1